Owner's Manual

78
STORAGE
If the fresh water supply is
insufficient it may be necessary
to temporarily cover the three
water intakes with duct tape as
shown on the following page.
COOLING SYSTEM INDICATOR
GARDEN HOSE ADAPTER
(FLUSH KIT COUPLER)
Running the engine without good
water circulation can cause
overheating and water pump damage.
Distributor’s Limited Warranty.
Remove the sealing washer from
the wash plug and install the
sealing washer on the flush kit
coupler.
Install the flush kit coupler into the
WASH plug hole and connect a
fresh water hose to the garden
hose adapter.
Move the gearshift lever or control
lever to the N (neutral) position.
Flush the outboard motor in the
neutral position only.
Turn on the fresh water supply to
the flush kit coupler.
Damage caused by running the
outboard motor without sufficient
cooling water is not covered by the
Start the engine. Monitor the
cooling system indicator. Stop the
engine if water does not come out
of the cooling system indicator and
check the fresh water supply.
4.
5.
2.
3.
6.
04/03/15 11:08:54 31ZW3600_079