Owner's Manual

60
(1)
2. Swingarm bearings should be checked
by pushing hard against the side of the
rear wheel while the motorcycle is on
the center stand. Freeplay indicates
worn bearings.
3. Carefully inspect all front and rear
suspension fasteners for tightness.
SIDE STAND
Refer to the safety precautions on page 40.
Check the side stand spring (1) for damage
and loss of tension, and the side stand
assembly for freedom of movement.
(1) Side stand spring¼lkbM LVSaM fLizax½
If the side stand is squeaky or stiff, clean
the pivot area and lubricate the pivot bolt
with clean engine oil.
WHEEL REMOVAL
Refer to the safety precautions on page 40.
Front Wheel Removal
(Disc type)
1. Place the vehicle on its center stand.
2. Raise the front wheel off the ground by
placing a support block under the
engine.
3. Remove the speedometer cable (1) by
pushing the tab (2).
4. Remove the front axle nut (3).
5. Remove the front axle shaft (4) and
the wheel.
Do not depress the brake lever when the
wheel is off the vehicle. The caliper piston
will be forced out of the cylinder with
subsequent loss of brake fluid. If this occurs,
servicing of the brake system will be