Operation Manual

89
ASSEMBLY
Hanger Kit Installation
1. Remove the center beam.
2. Loosely install the hanger to the center beam using the hanger
bracket and two
8×20 mm flange bolts.
3. Reinstall the center beam. Make sure to tighten the four 8×16 mm
bolts securely.
4.
Position the hanger at the generator’s center, and tighten the two
8×20 mm bolts securely.
TO
RQUE: 14–19
lbf·ft (20–25 N·m, 2.0–2.6 kgf·m)
8×20 mm FLANGE BOLT (2)
HANGER BRACKET
CENTER BEAM
8×16 mm
FLANGE BOLT (4)
HANGER
31Z266100.book 89 ページ ２０１４年１２月５日 金曜日 午後５時７分