User's Manual

GENERATOR USE
CONNECTIONS TO A BUILDING’S ELECTRICAL SYSTEM
Connections for standby power to a building’s electrical system must
be made by a qualified electrician. The connection must isolate the
generator power from utility power, and must comply with all appli-
cable laws and electrical codes.
Improper connections to a building’s electrical system can allow
electrical current from the generator to backfeed into the utility
lines. Such backfeed may electrocute utility company workers or
others who contact the lines during a power outage. Consult the
utility company or a qualified electrician.
Improper connections to a building’s electrical system can allow
electrical current from the utility company to backfeed into the
generator. When utility power is restored, the. generator may
explode, burn, or cause fires in the building’s electrical system.
GROUND SYSTEM
Honda portable generators have a system ground that connects
generator frame components to the ground terminals in the AC
output receptacles. The AC newtral wire is connected to the system
ground.
SPECIAL REQUIREMENTS
There may be Federal or State Occupational Safety and Health
Administration (OSHA) regulations, local codes, or ordinances that
apply to the intended use of the generator. Please consult a qualified
electrician, electrical inspector, or the local agency having jurisdic-
tion.
l In some areas, generators are required to be registered with local
utility companies.
l If the generator is used at a construction site, there may be addi-
tional regulations which must be observed.
19