Full Product Manual

47
SERVICING YOUR GENERATOR
5. Inspect the spark plug. Replace it
if the electrode is worn or if the
insulator is cracked, chipped, or
fouled.
6. Measure the spark plug
electrode gap with a wire-type
feeler gauge. Correct the gap, if
necessary, by carefully bending
the side electrode.
The gap should be:
0.024–0.028 in (0.6–0.7 mm)
7. Make sure that the spark plug sealing washer is in good condition,
and thread the spark plug in by hand to prevent cross-threading.
8. After the spark plug is seated, tighten with a spark plug wrench to
compress the sealing washer.
If reinstalling a used spark plug, tighten 1/8–1/4 turn after the spark
plug seats.
If installing a new spark plug, tighten 1/2 turn after the spark plug
seats.
TORQUE: 8.7 lbf·ft (12 N·m, 1.2 kgf·m)
A loose spark plug can overheat and damage the engine.
Overtightening the spark plug can damage the threads in the
cylinder head.
9. Reinstall the spark plug cap on the spark plug securely.
10. Reinstall the spark plug maintenance cover.
SIDE ELECTRODE
SEALING WASHER
0.024–0.028 in
(0.6–0.7 mm)
INSULATOR
31Z448020.book 47 ページ ２０１９年２月８日 金曜日 午前９時１６分