Replacement Part List

49
SERVICING YOUR GENERATOR
AIR CLEANER SERVICE
1. Loosen the maintenance cover
screw and remove the
maintenance cover.
2. Press the latch tab on the top of
the air cleaner case, and remove
the air cleaner cover.
3. Check the foam air filter to be
sure it is clean and in good
condition. If the foam air filter is
dirty, clean it as described on
page 50. Replace the foam air
filter if it is damaged.
4. Reinstall the air filter.
5. Make sure that the rubber seal is
set in the groove of the air
cleaner cover.
6. Reinstall the air cleaner cover by
inserting the lower tab and the
latch tab.
7. Reinstall the maintenance cover,
and tighten the maintenance
cover screw securely.
Operating the engine without an air filter or with a damaged air filter
will allow dirt to enter the engine, causing rapid engine wear. This
type of damage is not covered by the Distributor’s Limited Warranty.
MAINTENANCE COVER SCREW
MAINTENANCE COVER
AIR CLEANER CASE
FOAM AIR
FILTER
AIR CLEANER
COVER
RUBBER SEAL
LATCH TAB
LOWER TAB
31Z406040.book 49 ページ ２０１８年１月１８日 木曜日 午後１時２０分