Operation Manual

AC OPERATION
1. Start the engine (refer to page 24).
2. Plug in the appliance.
Substantial overloading will switch off the circuit breaker. Marginal
overloading may not switch off the circuit breaker, but it will shorten the
service life of the generator.
Be sure that all appliances are in good working order before connecting them
to the generator. If an appliance begins to operate abnormally, becomes
sluggish, or stops suddenly, turn off the generator engine switch immediately.
Then disconnect the appliance and examine it for signs of malfunction.
3. Check the frequency meter to verify that the generator is operating at 60Hz.
If it is not, turn the governor adjustment screw to increase or decrease
engine speed until the correct frequency is obtained (meter bar next to 60
will vibrate).
If an overloaded circuit trips the AC circuit breaker, reduce the electrical load
on the circuit, and wait a few minutes before resuming operation.
The green indicator inside the circuit breaker button will pop out to show that
the circuit breaker has switched off. Push the button in to reset the circuit
breaker.
AC CIRCUF BREAKER
FREdEN& 1
METER
GOVERNOR
ADJUSTMENT
SCREW
16