Replacement Part List

31
SERVICING YOUR TILLER
ENGINE OIL CHANGE
Drain the oil while the engine is warm to assure rapid and complete draining.
Make sure the area around the drain plug and the oil filler cap are clean.
1. Place a suitable container below the engine to catch the used oil, and
then remove the oil filler cap, drain plug, and sealing washer.
2. Allow the used oil to drain completely, and then reinstall the drain
plug with a new sealing washer. Tighten the plug securely.
TORQUE: 54 N∙m (5.5 kgf∙m, 40 lbf∙ft)
Improper disposal of engine oil can be harmful to the environment. If
you change your own oil, please dispose of the used oil properly. Put
it in a sealed container and take it to a recycling center. Do not
throw it in the trash, pour it on the ground, or pour it down a drain.
3. With the tiller in a level position, fill with the recommended oil
(see page 32) to the upper limit of the level gauge.
Maximum oil capacity: 10 US oz (0.30 L, 10.6 Imp oz)
Running the engine with a low oil level can cause engine damage.
This type of damage is not covered under the Distributor's Limited
Warranty (U.S.) / Distributor's Warranty (CA.).
4. Reinstall the oil filler cap securely.
Wash your hands with soap and water after handling used oil.
OIL FILLER CAP
DRAIN PLUG
SEALING
WASHER
(Replace)
DRAIN PLUG
31V146410.book 31 ページ ２０１８年３月７日 水曜日 午前９時８分