Replacement Part List
Table Of Contents
- F220
- INTRODUCTION
- CONTENTS
- TILLER SAFETY
- COMPONENT & CONTROL LOCATIONS
- BEFORE OPERATION
- OPERATION
- SERVICING YOUR TILLER
- THE IMPORTANCE OF MAINTENANCE
- MAINTENANCE SAFETY
- MAINTENANCE SCHEDULE
- REFUELING
- FUEL RECOMMENDATIONS
- ENGINE OIL LEVEL CHECK
- ENGINE OIL CHANGE
- ENGINE OIL RECOMMENDATIONS
- TRANSMISSION OIL LEVEL CHECK (USA model)
- AIR FILTER INSPECTION
- AIR FILTER CLEANING
- SPARK PLUG SERVICE
- CLUTCH CABLE ADJUSTMENT
- THROTTLE CABLE ADJUSTMENT
- SPARK ARRESTER SERVICE (optional part)
- STORAGE
- TRANSPORTING
- TAKING CARE OF UNEXPECTED PROBLEMS
- TECHNICAL INFORMATION
- CONSUMER INFORMATION
- QUICK REFERENCE INFORMATION
34
SERVICING YOUR TILLER
3. Remove the recoil cover cap nuts and remove the recoil cover.
4. Remove the fuel tank cap, neck seal, and fan cover. Carefully
remove the choke rod from the choke valve hole as shown.
5. Reinstall the fuel tank cap to prevent foreign objects from entering
the fuel tank.
6. Make sure the area around the oil filler cap is clean. Remove the
transmission oil filler cap and add the recommended oil to the upper
limit (see page 33).
Maximum oil capacity: 0.95 US qt (0.9 L)
Recommended oil:
API SERVICE category SJ or later (or equivalent), SAE 5W-30
7. Reinstall the oil filler cap. Reinstall the oil level check bolt and a new
sealing washer, and tighten the bolt securely.
TORQUE: 39 N∙m (4.0 kgf∙m, 29 lbf∙ft)
Wash your hands with soap and water after handing used oil.
CAP NUT (3)
RECOIL COVER
FUEL TANK CAP
NECK SEAL
FAN COVER
CHOKE ROD
CHOKE VALVE
HOLE
TRANSMISSION
OIL FILLER CAP
31V146410.book 34 ページ ２０１８年３月７日 水曜日 午前９時８分