Replacement Part List
Table Of Contents
- F220
- INTRODUCTION
- CONTENTS
- TILLER SAFETY
- COMPONENT & CONTROL LOCATIONS
- BEFORE OPERATION
- OPERATION
- SERVICING YOUR TILLER
- THE IMPORTANCE OF MAINTENANCE
- MAINTENANCE SAFETY
- MAINTENANCE SCHEDULE
- REFUELING
- FUEL RECOMMENDATIONS
- ENGINE OIL LEVEL CHECK
- ENGINE OIL CHANGE
- ENGINE OIL RECOMMENDATIONS
- TRANSMISSION OIL LEVEL CHECK (USA model)
- AIR FILTER INSPECTION
- AIR FILTER CLEANING
- SPARK PLUG SERVICE
- CLUTCH CABLE ADJUSTMENT
- THROTTLE CABLE ADJUSTMENT
- SPARK ARRESTER SERVICE (optional part)
- STORAGE
- TRANSPORTING
- TAKING CARE OF UNEXPECTED PROBLEMS
- TECHNICAL INFORMATION
- CONSUMER INFORMATION
- QUICK REFERENCE INFORMATION
35
SERVICING YOUR TILLER
Assembly
8. Remove the fuel tank cap. Verify the choke lever is in the CLOSED
position and reinstall the fan cover by inserting the choke rod into
the choke valve hole.
• The choke lever will not operate if the choke rod is not inserted
correctly into the choke valve hole as shown below.
9. Reinstall the neck seal and fuel tank cap as shown.
10.Reinstall the recoil cover, and tighten the recoil cover cap nuts
securely.
NECK SEAL
CAP NUT (3)
RECOIL COVER
FUEL TANK CAP
NECK SEAL
FAN COVER
CHOKE ROD
CHOKE VALVE
HOLE
31V146410.book 35 ページ ２０１８年３月７日 水曜日 午前９時８分