Replacement Part List
Table Of Contents
- F220
- INTRODUCTION
- CONTENTS
- TILLER SAFETY
- COMPONENT & CONTROL LOCATIONS
- BEFORE OPERATION
- OPERATION
- SERVICING YOUR TILLER
- THE IMPORTANCE OF MAINTENANCE
- MAINTENANCE SAFETY
- MAINTENANCE SCHEDULE
- REFUELING
- FUEL RECOMMENDATIONS
- ENGINE OIL LEVEL CHECK
- ENGINE OIL CHANGE
- ENGINE OIL RECOMMENDATIONS
- TRANSMISSION OIL LEVEL CHECK (USA model)
- AIR FILTER INSPECTION
- AIR FILTER CLEANING
- SPARK PLUG SERVICE
- CLUTCH CABLE ADJUSTMENT
- THROTTLE CABLE ADJUSTMENT
- SPARK ARRESTER SERVICE (optional part)
- STORAGE
- TRANSPORTING
- TAKING CARE OF UNEXPECTED PROBLEMS
- TECHNICAL INFORMATION
- CONSUMER INFORMATION
- QUICK REFERENCE INFORMATION
36
SERVICING YOUR TILLER
AIR FILTER INSPECTION
Press the latch tabs on the fuel tank side of the air cleaner cover,
remove the air cleaner cover, and remove the filter.
Check the filter to be sure it is clean and in good condition. If the filter
is dirty, remove the filter and clean it as described on page 37. Replace
the filter if it is heavily clogged or damaged.
Reinstall the filter and air cleaner cover. Make sure the latch tabs are
secured.
Operating the engine without an air filter, or with a damaged air filter,
will allow dirt to enter the engine, causing rapid engine wear. This type
of damage is not covered by the Distributor's Limited Warranty (U.S.) /
Distributor's Warranty (CA.).
LATCH TABS
AIR CLEANER COVER
AIR FILTER
HOOKS
31V146410.book 36 ページ ２０１８年３月７日 水曜日 午前９時８分