Replacement Part List
Table Of Contents
- F220
- INTRODUCTION
- CONTENTS
- TILLER SAFETY
- COMPONENT & CONTROL LOCATIONS
- BEFORE OPERATION
- OPERATION
- SERVICING YOUR TILLER
- THE IMPORTANCE OF MAINTENANCE
- MAINTENANCE SAFETY
- MAINTENANCE SCHEDULE
- REFUELING
- FUEL RECOMMENDATIONS
- ENGINE OIL LEVEL CHECK
- ENGINE OIL CHANGE
- ENGINE OIL RECOMMENDATIONS
- TRANSMISSION OIL LEVEL CHECK (USA model)
- AIR FILTER INSPECTION
- AIR FILTER CLEANING
- SPARK PLUG SERVICE
- CLUTCH CABLE ADJUSTMENT
- THROTTLE CABLE ADJUSTMENT
- SPARK ARRESTER SERVICE (optional part)
- STORAGE
- TRANSPORTING
- TAKING CARE OF UNEXPECTED PROBLEMS
- TECHNICAL INFORMATION
- CONSUMER INFORMATION
- QUICK REFERENCE INFORMATION
43
STORAGE
STORAGE PREPARATION
Proper storage preparation is essential for keeping your tiller trouble
free and looking good. The following steps will help to keep rust and
corrosion from impairing your tiller’s function and appearance, and will
make the engine easier to start when you use the tiller again.
Cleaning
1. Wash the tiller, including the underside.
Engine
Wash the engine by hand, and be careful to prevent water from
entering the air cleaner.
• Using a garden hose or pressure washing equipment can force
water into the air cleaner. Water in the air cleaner will soak the
filter element and can enter the carburetor or engine cylinder,
causing damage.
• Water contacting a hot engine can cause damage. If the engine
has been running, allow it to cool for at least half an hour before
washing.
Tiller
If using a garden hose or pressure washing equipment to clean the
tiller, be careful to avoid getting water on the belts.
Spraying water on hot tine shaft bearings can cause them to be
damaged from cooling too quickly.
31V146410.book 43 ページ ２０１８年３月７日 水曜日 午前９時８分