Replacement Part List
Table Of Contents
- F220
- INTRODUCTION
- CONTENTS
- TILLER SAFETY
- COMPONENT & CONTROL LOCATIONS
- BEFORE OPERATION
- OPERATION
- SERVICING YOUR TILLER
- THE IMPORTANCE OF MAINTENANCE
- MAINTENANCE SAFETY
- MAINTENANCE SCHEDULE
- REFUELING
- FUEL RECOMMENDATIONS
- ENGINE OIL LEVEL CHECK
- ENGINE OIL CHANGE
- ENGINE OIL RECOMMENDATIONS
- TRANSMISSION OIL LEVEL CHECK (USA model)
- AIR FILTER INSPECTION
- AIR FILTER CLEANING
- SPARK PLUG SERVICE
- CLUTCH CABLE ADJUSTMENT
- THROTTLE CABLE ADJUSTMENT
- SPARK ARRESTER SERVICE (optional part)
- STORAGE
- TRANSPORTING
- TAKING CARE OF UNEXPECTED PROBLEMS
- TECHNICAL INFORMATION
- CONSUMER INFORMATION
- QUICK REFERENCE INFORMATION
49
TRANSPORTING
Follow Honda's recommendations for safe loading, unloading, and
transporting your tiller.
BEFORE LOADING
If the engine has been running, allow it to cool for at least 15 minutes
before loading the tiller on the transport vehicle. A hot engine and
exhaust system can burn you and can ignite some materials.
To prevent fuel spillage, drain fuel from the fuel tank (see page 46).
Always turn the engine switch to the OFF position. Make sure to turn
the fuel valve OFF.
LOADING AND UNLOADING
If a suitable loading ramp is not available, two people should lift the
tiller on and off the transport vehicle while holding the tiller level.
Position the tiller so it sits flat on the bed of the transport vehicle. Tie
the tiller down with rope or straps. Keep the tie-down rope or straps
away from the controls, adjustment levers, cables, and the carburetor.
The handlebar can be folded either front or back so the tiller will take
up less space (see page 21).
Fold to the back side. Fold to the front side.
31V146410.book 49 ページ ２０１８年３月７日 水曜日 午前９時８分