Operation Manual

Rear wheel tread adjustment

WIDE TREAD

NARROW TREAD

WHEEL PIN

RETAINING PIN

REAR WHEEL

WIDE TREAD:

500 mm (19.7 in)

NARROW TREAD:

300 mm (11.8 in)

Set the tiller on a firm level ground and hold it securely by placing a

suitable block under the transmission case and raising the rear

wheels off the ground.

Remove the retaining pin and wheel pin, and remove the rear

wheels.

Reverse and slide the rear wheels onto the wheel shaft.

Insert the wheel pin by aligning the pin holes and install the

retaining pin. Be sure to install the right and left rear wheels in the

symmetrical positions.

Rear wheel position can be changed to adjust the rear wheel tread in

accordance with the tilling width.