Product Manual

6
Moving the Tiller
The tiller has wheels to allow easy maneuvering to and from the work
area.
Do not transport the tiller with the engine running.
Install the wheels by inserting the wheel mount onto the drag bar.
Secure with the locking clevis pin.
Before tilling, remove the wheels from the drag bar.
STARTING THE ENGINE
1. Move the engine switch to the ON position.
2. To start a cold engine, move the choke lever up to the CLOSED
(E) position.
To restart a warm engine, leave the choke lever down in the OPEN
position.
3. To start a cold engine, or after refueling an engine that has run out
of fuel, press the priming bulb repeatedly until fuel can be seen in
the clear-plastic fuel-return tube.
To restart a warm engine, it is not necessary to press the priming
bulb.
4. Place your left hand on the carrying handle and hold it firmly. Make
sure your feet are away from the tiller tines. With your right hand,
pull the starter grip lightly until you feel resistance, then pull briskly.
Return the starter grip gently.
5. If the choke lever was moved to the CLOSED (E) position,
gradually move it to the OPEN position as the engine warms up.
Allow the engine to warm up for a few moments after starting a
cold engine.
The tiller tines should not rotate with the engine idling. If there is
rotation at idle, adjust the idle speed correctly before using the tiller
(
page 12).
DRAG BAR
CLIP
LOCKING
CLEVIS PIN
WHEEL MOUNT
TRANSPORT POSITION STORAGE POSITION
ENG. SW.
ON
OFF OFF
CHOKE
LEVER
(UP to
close)
PRIMING
BULB
STARTER
GRIP
CARRYING
HANDLE
FUEL
RETURN
TUBE
(clear
plastic)