User's Manual

ENGLISH
REFUELING
Recommended Fuel
ENGINE OIL
Recommended Oil
Pump type:
Standard/Tiller type:
AMBIENT TEMPERATURE
SAE Viscosity Grades
Standard/Pump type: Tiller type:
FUEL FILLER CAP
MAXIMUM
FUEL LEVEL
8
Unleaded gasoline
Pump octane rating 86 or higher
Research octane rating 91 or higher
Pump octane rating 86 or higher
U.S.
Except U.S.
Keep gasoline away from appliance pilot lights, barbecues,
electric appliances, power tools, etc.
This engine is certified to operate on unleaded gasoline with a
pump octane rating of 86 or higher (a research octane rating of 91
or higher).
Refuel in a well-ventilated area with the engine stopped. If the
engine has been running, allow it to cool first. Never refuel the
engine inside a building where gasoline fumes may reach flames
or sparks.
You may use regular unleaded gasoline containing no more than
10% Ethanol (E10) or 5% Methanol by volume. In addition,
Methanol must contain cosolvents and corrosion inhibitors. Use of
fuels with content of Ethanol or Methanol greater than shown
above may cause starting and/or performance problems. It may
also damage metal, rubber, and plastic parts of the fuel system.
Engine damage or performance problems that result from using a
fuel with percentages of Ethanol or Methanol greater than shown
above are not covered under warranty.
Gasoline is highly flammable and explosive, and you
can be burned or seriously injured when refueling.
Stop engine and keep heat, sparks, and flame away.
Refuel only outdoors.
Wipe up spills immediately.
Fuel can damage paint and some types of plastic. Be careful not to
spill fuel when filling your fuel tank. Damage caused by spilled
fuel is not covered under the
Distributor’s Limited Warranty.
Never use stale or contaminatedgasoline or oil/gasoline mixture.
Avoid getting dirt or water in the fuel tank.
Check the fuel level by looking through the translucent fuel tank.
If the fuel level is low, refuel in a well-ventilated area with the
engine stopped. If the engine has been running, allow it to cool.
Spilled fuel is notonly a fire hazard, it causes environmental
damage. Wipe up spills immediately.
Oil is a major factor affecting performance and service life. Use
4-stroke automotive detergent oil.
To refuel, rest the engine a level surface with the fuel filler cap
facing up, as shown. Remove the fuel filler cap, and fill the tank
with gasoline to the bottom of the filler neck. Refuel carefully to
avoid spilling fuel. Do not overfill. There should be no fuel in the
filler neck. After refueling, tighten the fuel filler cap securely.
The recommended operating range of this engine is 5°C to 40°C
(41°F to 104°F).
The recommended operating range of this engine is 5°C to 40°C
(23°F to 104°F).
SAE 10W-30 is recommendedfor general use. Other viscosities
shown in the chart may be used when the average temperature in
your area is within the indicated range.
Use 4-stroke motor oil that
meets or exceeds the
requirements for API service
classification SJ or later (or
equivalent). Always check the
API service label on the oil
container to be sure it includes
the letters SJ or later (or
equivalent).
1.
2.
06/11/06 12:22:36 32Z6J600_008