Owner's Manual

Uneven mowing
1. Lawn tractor speed too fast-shift to lower speed.
2. Grass accumulation-
Clean inside deck.
inside deck.
3. Dull blade.
) Replace blade or see your authorized
Honda dealer.
4. Tires improperly inflated.-
Check tire pressure (see page 25).
5. Mower not level.
~Check cutter deck mounting.
See your authorized Honda dealer.
6. Wrong cutter deck height.-+
Change to proper height.
7. Chute clogged (if equipped
-----) Empty grass bag and chute.
with optional grass bag).
8. Lawn wet
hallow to dry before cutting.
9. Cutter deck set too low.-
Set cutter deck higher.
10. Not overlapping cut enough- See page 37.
to compensate for grass
conditions.
11. Throttle setting too low. -Set to FAST.
Clogged cutter deck discharge chute.
1. Wrong blade.
muse a genuine Honda blade or
equivalent.
2. Deck too low.
bRaise deck and adjust deck height
properly.
3. Engine overloaded.
*Operate at full throttle. Use lower
speed range. Set cutter deck higher
then desired height for first pass,
then cut to desired height on second
pass.
4. Wet lawn.
&Mow when lawn is dry.
5. Lawn too tall. ) Set cutter deck higher than desired
height for first pass, then cut to
desired height on second pass.
6. Low engine rpm.
@ Open throttle fully.
7. Grass bags full
) Empty grass bags.
(Optional part).
8. Blades installed upside down. -Check blade installation (see page
58).
68