User guide

3. UNPACKING AND ASSEMBLY

For storage and transport reasons, some components of the machine are not

directly installed in the factory, but have to be assembled after their removal from

the packing. Final assembly is carried out by following these simple instructions.

The machine is supplied without engine oil or fuel. Before

starting up the engine, fill with oil and fuel following the instructions.

3.1 UNPACKING

When unpacking the machine, take care to gather all individual parts and fittings,

and do not damage the cutting deck when taking the machine off the base pallet.

The packing contents:

– the machine;

– the steering wheel;

– the seat;

– the front bumper (if fitted);

– the grass-catcher brackets;

– the grass-catcher components;

– the battery charger;

– an envelope containing:

– the operator’s manuals and documents,

– the nuts and bolts including a pin for blocking the steering wheel,

– 2 starter keys and a spare 10 A fuse.

To prevent damaging the cutting deck when getting the ma-

chine down from the pallet, take it to the maximum height (

☛

4.6) and be very

careful. In the hydrostatic drive models, to get the machine off the pallet and to

move it more easily, put the drive disengage lever in position «B» (

☛

4.34).

3.2 FITTING THE STEERING WHEEL

Put the machine on a flat surface and

straighten up the front wheels.

Fit the steering wheel (1) onto the pro-

truding shaft (2) with the spokes directed

towards the seat.

Line up the hole in the steering wheel hub

NOTE

IMPORTANT

EN 9UNPACKING AND ASSEMBLY