Operation Manual

2. REDUCTION GEAR OIL

1. Remove the oil filler cap and wipe the dipstick clean.

2. Insert the dipstick into the filler neck but do not screw it in.

3. If the level is low, fill to the upper level mark with the same oil recom-

mended for the engine (see engine oil recommendations on page 7).

Oil capacity: 0.5 e (0.53 US qt 0.44 Imp qt)

, DIPSTICK/FILLER CAP

UPPER LEVEL

DRAIN BOLT

1. Remove the oil level bolt.

2. Check the oil level; it should reach the edge of the oil level bolt hole. If

the oil level is low, remove the filler bolt, and add oil until it starts to flow

-out the oil level bolt hole. Use the same oil recommended for the engine

(see engine oil recommendations on page 7).

3. Install the oil level bolt and filler bolt. Tighten them securely.

Oil capacity: 0.15 e (0.16 US qt, 0.13 Imp qt)

OIL LEVEL

.LER BOLT