Operation Manual

1. Unscrew the wing nut, remove the air cleaner cover and remove the

element.

2. Wash the element in a solution of household detergent and warm water,

then rinse thoroughly, or wash in nonflammable or high flash point sol-

vent. Allow the element to dry thoroughly.

3. Soak the element in clean engine oil and squeeie out the excess oil.

The engine will smoke during initial start-up if too much oil is left in the

element.

4. Empty the oil from the air cleaner case and wash out any accumulated

dirt with nonflammable or high flash point solvent. Dry the case.

5. Fill the air cleaner case to the level mark with the same oil tha.t is recom-

mended for the engine (see engine oil recommendations on page 7).

6. Reinstall the element and the cover.

AIR CLEANER COVER

ELEMENT