Owner's manual

STORAGE

3. With the mower in an upright position, open the clip director, start

the engine outdoors, engage the blade control lever, and let the

engine run until it reaches normal operating temperature to

evaporate any water remaining on the engine.

4. Stop the engine and allow it to cool.

5. After the lawn mower is clean and dry, touch up any damaged

paint (touch-up paint part numbers are on page 73), and coat other

areas that may rust with a light film of oil. Lubricate the control

cable cores with a silicone spray lubricant (page 73).

Charging the Battery (HMA type only)

To assure maximum reliability, the battery should be recharged (boost

charged) both before and after prolonged storage. A plug-in charger is

provided to recharge the battery (see page 50).

NOTICE

Do not charge the battery for more than 24 hours or the battery may be

damaged. Disconnect the battery charger from the battery before

storing the lawn mower.