Operation Manual

E 47
SET-UP
Unpacking
Remove all the cardboard from the
mower, including the piece around
the handlebar.
Handlebar Setup
Loosen the two locking knobs [1] on
the lower handlebar enough to raise
the handlebar into the mowing
position. Hold the flywheel brake
lever [2] against the handlebar, and
unfold the handlebar into the
mowing position. Remove the piece
of paper between the handlebar and the frame. Once the handlebar is
in place, tighten the knobs securely.
Grass Bag Assembly
Slide the grass bag frame [1] into the grass bag [2] and attach the clips
[3] as shown.
Lift the rear discharge guard [4],
and install the grass bag.
[1] (2)
[2]
[2]
[1]
[3]
[1]
GRASS BAG
HANDLE
[4]
1E-HRZ536C.book Page 47 Thursday, September 8, 2005 11:16 AM