Operation Manual

55
Check each part to verify it is in its proper position before resuming
operation.
When the snowblower and auger stop moving/turning, move the
main shift lever to the N (neutral) position, release the drive clutch
lever once, and then squeeze it again.
Do not turn the mode selector switch to another position while the
snowblower is moving. The electronic control unit will interpret this
as a failure; the snowblower will stop moving and the auger will stop
turning.
[HSM1390i]
CHUTER CONTROL SWITCH
AUGER HOUSING CONTROL SWITCH
RESET SWITCH
Clearing in AUTO mode (HSM1390i)
Setting the mode selector switch at the AUTO position can
simplify clearing the snow. AUTO mode keeps the auger from
rising, adjusts the engine speed automatically, etc.
If you return the auger to the
initial height position by
pushing the reset switch, the
auger can hit against the road
surface or can be raised from
the road, resulting in some
snow left on the ground,
depending on the road
condition and the position of
the snowblower. Adjust the
auger height position as
needed.
You can return the auger to
the initial height position by
pushing the reset switch.
Operate the auger housing
control switch to adjust the
auger to be parallel to the road
surface (see pages through
).
Operate the chuter control
switch to adjust the snow
discharge direction and angle
(see page ).
1)
2)
3a.
51
53
30
11/06/18 14:57:36 32V15630_057