Operation Manual

59
AUGER HOUSING CONTROL SWITCH
RESET SWITCH (ZE type)
N (neutral)
DRIVE CLUTCH
LEVER
MAIN SHIFT LEVER
If you return the auger to the
initial height position by
pushing the reset switch, the
auger can hit against the road
surface or can be raised from
the road, resulting in some
snow left on the ground,
depending on the road
condition and the position of
the snowblower. Adjust the
auger height position as
needed.
You can return the auger to
the initial height position by
pushing the reset switch.
Operate the auger housing
control switch to adjust the
auger to be parallel to the road
surface (see pages through
).
Check that the main shift lever
is in the N (neutral) position and
squeeze the drive clutch lever.
3)
[ZE type]
4)
51
53
11/06/18 14:58:10 32V15630_061