Operation Manual

＋
Be careful when
removing this screw as the
head of the screw can strip out.
Remove the screw at the base of
the transmitter with a small
Phillips-head screwdriver.
Remove the old battery and note
the polarity. Make sure the
polarity of the new battery is the
same ( side facing down), then
insert it in the keypad.
To replace the battery:
Separate the keypad from the
transmitter by pushing any button
from outside.
Place a cloth on the edge of the
keypad to prevent scratches, and
remove the upper half by carefully
prying on the edge with a coin.
Snap the two halves of the keypad,
then install the parts in reverse
order.
1.
2.
3. 4.
5.
CONTINUED
Remote Transmitter
137
NOTE:
SCREW
BATTERY
COIN
KEYPAD
12/07/13 16:54:24 31TM8630_142
Instruments and Controls
TOC
2013 Insight