Operation Manual

32
Setting the lawnmower operation
Mowing start points
Home screen J [2.Garden setup] J [1.Auto mode] J
[1.Mowing start points] J [1.Point 1] to [5.Point 5]
The lawnmower travels to this location along the
boundary wire, and then turns away from the
boundary wire to begin mowing. This allows you to
send the lawnmower to an area which is difcult to
access.
TIPS
Don’t make the distance value bigger than it
needs to be. This will maximise the cutting
time.
1
Select (Clockwise) or
(Anticlockwise), enter the values of the
distance from the docking station to start
cutting, and enter a percentage of the
ratio which the lawnmower operates.
2
Select [NEXT] and press the H button.
3
Enter the values of the width setting and
angle, and press the H button.
NOTE:
- By selecting [TEST], you can check
the settings of each start point before
mowing. For details, see “Test start
point” (M page 43).
4
Press the G button to return to the
previous screen.
Mowing start points 2/2
Point Width Angle
1 3 - 6 5 0 - 1 5 0
2 3 - 6 5 0 - 1 5 0
3 3 - 6 5 0 - 1 5 0
4 3 - 6 5 0 - 1 5 0
5 3 - 6 5 0 - 1 5 0
TEST (0-1 0) (1 0‘- 1 7 0‘)
Mowing start points 1/2
Point / (0-400m)
1 / 0 0 0 m 0 0 0 %
2 / 0 0 0 m 0 0 0 %
3
/ 0 0 0 m 0 0 0 %
4
/ 0 0 0 m 0 0 0 %
5
/ 0 0 0 m 0 0 0 %
NEXT
Set an area operation ratio
if you want to mow more
frequently from a certain start
point.
Set whether the lawnmower
should travel clockwise or
anticlockwise along the
boundary wire to reach a start
point.
Sets the minimum and
maximum distance between
the lawnmower and the
boundary wire when following
the boundary wire.
Sets the distance from the
docking station to start cutting.
When leaving the boundary
wire, set the minimum and
maximum angle to turn from
the boundary wire.
Menu screen
VP7Z.indb 32 2014/12/18 14:25:59