Operation Manual

33
To adjust the adjuster to the standard
position, proceed as follows:
1. Turn the spring preload adjuster knob (1)
counterclockwise until it will no longer turn
(lightly seats). This is the full LOW
position.
2. The adjuster is set in the standard position
when the spring preload adjuster knob is
turned clockwise 11 clicks.
The rear shock absorber assembly includes
a damper unit that contains high pressure
nitrogen gas. Do not attempt to disassemble
or service the damper; it cannot be rebuilt
and must be replaced when worn out.
Disposal should only be done by your Honda
dealer. The instructions found in this ownerʼs
manual are limited to adjustment of the shock
assembly only.
(1) Spring preload adjuster knob
(1)