Security System Owner’s Manual © 2004 American Honda Motor Co., Inc. - All Rights Reserved. ODYSSEY Kit No.
Contents Introduction ..................................................... 3 Emergency Disarming During the Panic Alarm Activation ............ 4 During the Entry Delay Time ..................... 4 System Controls Arming Mode (MANUAL AUTOMATIC) . 5 Arming Mode (AUTOMATIC MANUAL) .. 6 Valet Placing the System in the Valet Mode ...... 7 In the Valet Mode ...................................... 8 Exit From the Valet Mode .......................... 9 Arming Arming Methods ......................................
Introduction Congratulations on your purchase of this Honda Security System. Your Honda Security System is the product of years of research and development. It will give you many years of reliable performance, protection, and convenience. Due to the expertise required to properly install the Honda Security System, we highly recommend that the installation be performed by your Honda dealer. Proper wiring and component placement are essential for optimum system performance.
Emergency Disarming During the Panic Alarm Activation • The system can be disarmed using the ignition key regardless of the method used to arm the system. • This method of disarming also serves as an emergency override if the remote control transmitter cannot be used. 1 2 Enter the vehicle and insert the ignition key. Turn the ignition key to the ON (II) position. The system stops the panic alarming when the ignition key is turned to the ON (II) position. Check to see the status LED goes off.
System Controls Arming Mode (MANUAL AUTOMATIC) This section explains how to change the arming mode from MANUAL to AUTOMATIC. NOTE: The arming mode of the Security System is preset to MANUAL arming. NOTE: Steps 1 thru 5 must be completed within 5 seconds. Insert the ignition key. 2 Remove the ignition key from the ignition switch. (All the way out) 3 4 within 5 seconds 1 Insert the ignition key. Remove the ignition key from the ignition switch. (All the way out) 5 Insert the ignition key.
System Controls Arming Mode (AUTOMATIC MANUAL) 1 ON This section explains how to change the arming mode from AUTOMATIC to MANUAL. Turn the ignition key from the ON (II) position to the LOCK (0) position. Remove the key from the ignition switch. LOCK Status Open a door or the tailgate and close it. (The EXIT delay starts.) LED Check that the status LED blinks. 2 4625030B 4625051B NOTE: Steps 3 thru 7 must be completed within 5 seconds. Insert the ignition key.
Valet Placing the System in the Valet Mode (Valet Mode can be changed only from Automatic Arming Mode) • When the security system is placed in the valet mode, it is temporarily placed on hold. When in the valet mode, the system cannot be armed, but panic mode is still functional. This is a convenient feature if the car is to be washed, serviced, or valet parked. • Before removing the ignition key, opening/closing of the door or tailgate is not related to set valet mode.
Valet If you follow either procedure below, the Status LED blinks once to show the system is in the Valet mode. In the Valet Mode: Status LED 4625060B Open one of the doors or the tailgate. The Status LED blinks once. 4625051B Status LED After turning the ignition switch to LOCK (0), remove the ignition key. The Status LED blinks once. 4625051B Keyless/Security during the Valet Mode.
Valet Exit From the Valet Mode 1 With the system in the Valet mode, take the key out of the ignition switch. 2 Press the UNLOCK button on the remote control transmitter. 2 3 Observe that the Status LED flashes twice, indicating that the system is out of the Valet mode. The system is now in the Disarm mode. 4625051B 3 Status LED © 2004 American Honda Motor Co., Inc. - All Rights Reserved.
Arming Arming Methods There are two possible ways to arm the system: • MANUAL Arming (Remote Control) • AUTOMATIC Arming (Passive) Manual Arming (Remote Controlled) • When the main unit is set to MANUAL, the system is armed by using the remote control transmitter. This is the factory setting. • The system beeps three times. It does not arm itself unless any door or the tailgate is closed when the LOCK button is pressed. 1 2 Make sure the arming mode is set to MANUAL.
Arming • When the main unit is set to AUTOMATIC, the system arms automatically 20 seconds after the last door or the tailgate is closed*. • If a door or the tailgate is opened during the 20 seconds exit delay time, the timer resets and the 20 seconds exit delay time restarts after the last door or the tailgate is closed. • If the ignition key is inserted into the ignition switch during the exit delay time, the system will be disarmed. • The system beeps three times.
Arming Exit the vehicle, and close all the doors and the tailgate. 4625030B 4 20-sec exit delay time The system arms automatically 20 seconds after the last door or the tailgate is closed. Observe that: • The status LED flashes four times per second during the exit delay time, and once per 3 seconds after the system is armed. (Be sure to check that the status LED flashes.) • The parking lights flash once without a beep to confirm the system is armed. (Be sure to check that the lights flash.
Alarm Mode Alarm Triggered Mode • After the system is armed, opening of any door or the tailgate, or breaking of window glass will trigger the alarm. • If the door or tailgate is kept open, the alarm will continue to sound for 5 minutes. • If the battery is disconnected in the alarm mode, any attempt to reconnect the battery will send the alarm into the triggered mode. When the alarm is triggered, observe that: 1 • The horn sounds once per 1.5 seconds for one alarm duration (horn duration is 30 seconds).
Disarming Remote Control Disarming • Regardless of the method used to arm the system, the system can be disarmed using the remote control transmitter. 1 Press the UNLOCK button once on the remote control transmitter. Observe that: • The remote control LED illuminates. • The security system disarms and the parking lights flash twice when the alarm has not been triggered. If the alarm has been triggered, the horn sounds four times to tell you the alarm has been triggered.
Tripped Sensor Warning and Indication Tripped Sensor Warning 1 • The system will warn you that the security system has been tripped in your absence. If the system was tripped and automatically rearmed, observe that: • The horn sounds four times when the system is disarmed. 4625020B © 2004 American Honda Motor Co., Inc. - All Rights Reserved.
Tripped Sensor Warning and Indication Tripped Sensor Indication 1 2 • After disarming the system, if the tripped sensor warning indicator appears, you can identify which portion of the security system has been tripped by observing the number of flashes as shown below. • Information regarding the security system can be retrieved from the memory of the systems main control unit. Disarm the security system. Close the door and tailgate. Insert the ignition key.
Glossary Description ALARM DURATION The amount of time the horn sounds when the alarm is tripped or the panic feature is activated. The duration is 30 seconds. ARM To turn the security system’s protection on. * AUTOMATIC ARMING The optional mode in which the security system is armed automatically (passively) after all the doors and the tailgate are closed. The doors and tailgate do not lock when the system is armed.
Glossary Description EXTENDED EXIT ARMING If a door or the tailgate is opened during the exit delay time, the timer will reset and restart the countdown procedure when the specific door or the tailgate is closed. PANIC A mode in which the horn and lights are intentionally activated. Useful for attracting attention in case of an emergency. SENSOR CANCELLATION A feature that cancels (ignores) a particular sensor that has caused the alarm to be tripped consecutively for 5 minutes.
Specifications Main Unit Design ................................................................................................... Microprocessor, all solid state Operating Voltage ............................................................................... 13 V DC (8 V to 16 V allowable) Current Consumption (Arming) .................................................................................................... 2 mA Operating Temperature .............................................................
08E55-SHJ-1000-81 20 © 2004 American Honda Motor Co., Inc - All Rights Reserved. © 2004 American Honda Motor Co., Inc. - All Rights PrintedReserved.