OPERATING INSTRUCTIONS SECURITY SYSTEM KIT NO.: 08E51-EP4-101 © 2004 American Honda Motor Co., Inc. - All Rights Reserved.
Contents Introduction ..................................................... 3 Emergency Disarming During Alarming ........................................ 4 During the Entry Delay Time ..................... 4 System Controls Arming Mode (MANUAL AUTO) ............... 5 Arming Mode (AUTO MANUAL) ............... 6 Valet (Automatic Arming Mode only) Placing the System in the Valet Mode ...... 7 In the Valet Mode ...................................... 8 Exit From the Valet Mode ..........................
Introduction Congratulations on your purchase of this Honda Security System. Your Honda Security System is the product of years of research and development. It will give you many years of reliable performance, protection, and convenience. Due to the expertise required to properly install the Honda Security System, we highly recommend that the installation be performed by your Honda dealer. Proper wiring and component placement are essential for optimum system performance.
Emergency Disarming • The system can be disarmed using the Ignition key regardless of the method used to arm the system. • This method of disarming also serves as an emergency override if the remote control transmitter cannot be used. Disarming 1 Enter the vehicle and insert the ignition key. 0 2 Turn the ignition key to the “ON” (II) position. The security system will disarm when the ignition key is turned to the on position.
System Controls Arming Mode (MANUAL AUTO) This section explains how to switch the arming mode from MANUAL to AUTO. NOTE: Factory preset is MANUAL. Disarm the security system. Steps from 2 to 4 must be completed within 3 seconds. 2 Insert the ignition key, and remove the iginition key from the iginition switch. (All the way out.) 4713010M 3 within 3 seconds 1 Insert the ignition key, and remove the ignition key from the ignition switch.
System Controls Arming Mode (AUTO MANUAL) 1 This section explains how to switch the arming mode from AUTO to MANUAL. Turn the ignition key to the OFF position. Remove the key from the ignition switch. ON OFF 0 2 Open a door and close it. (The EXIT delay starts.) 3 4 NOTE: Steps 4 to 6 must be completed within 3 seconds. 4713010M 5 within 3 seconds Insert the ignition key, and remove the ignition key from the ignition switch.
Valet (Auto Arming Mode only) Placing the System in the Valet Mode (Valet Mode cannot be used in the Manual Arming Mode) When the security system is placed in the valet mode, it is temporarily placed on “hold.” When in the valet mode, the system cannot be armed, but panic mode is still functional. This is a convenient feature if the car is to be washed, serviced, or valet parked. Disarm the security system. Steps from 2 to 4 must be completed within 3 seconds.
Valet (Auto Arming Mode only) If you follow either procedure below, LED blinks once to show the system is in the Valet mode. In the Valet Mode: LED LED Open one of the doors. LED blinks once. After turning the ignition switch to OFF, remove the ignition key. LED blinks once. 0 Keyless/Security during the Valet Mode.
Valet (Auto Arming Mode only) Exit From the Valet Mode With the system in the Valet mode and the key out of the ignition switch. 1 Steps from 2 to 4 must be completed within 3 seconds. 2 4713010M 3 within 3 seconds Insert the ignition key, and remove the iginition key from the iginition switch. (All the way out.) Insert the ignition key, and remove the ignition key from the ignition switch. (All the way out) 4713010M 4 0 4 Status LED © 2004 American Honda Motor Co., Inc. - All Rights Reserved.
Arming There are two possible ways to arm the system: • MANUAL Arming (Remote Control) • AUTO Arming (Passive) Arming Methods Manual Arming (Remote Controlled) • When the main unit is set to “MANUAL,” the system is armed by using the remote control transmitter. This is the factory setting. • The system will “beep” 3 times, and not arm, if the trunk is not closed when the “LOCK” button is pressed. • If a door is open, the system will not arm when the “LOCK” button is pressed.
Arming Auto Arming (Passive) (Arms the security system without locking the doors.) 1 2 • When the main unit is set to “AUTO,” the system arms automatically 20 seconds after the last door or the trunk is closed*. • If a door or the trunk is opened during the 20 second exit delay time, the timer resets and the 20 second exit delay time restarts after the last door or the trunk is closed. • If the ignition key is inserted into the ignition switch during the exit delay time, the system will be disarmed.
Alarm Mode Alarm Triggered Mode • After the system is armed, the sound of breaking glass or the opening of any doors or the trunk (or hood)* will trigger the alarm. • If the door(s) is kept open, the alarm will continue to sound for 10 minutes. • If the battery is disconnected in the alarm mode, any attempt to reconnect the battery will send the alarm into the triggered mode. 1 When the alarm is triggered, you will observe the following: • The horn sounds once per 1.
Disarming Remote Controlled Disarming • Regardless of the method used to arm the system, the system can be disarmed using the remote control transmitter. 1 Press the “UNLOCK” button once on the remote control transmitter and the following will occur. The remote control LED illuminates. • The security system disarms and the parking lights flash twice when the Alarm has not been triggered. If the alarm has been triggered, the parking lights flash 3 times to tell you the alarm has been triggered.
Glass Hatch Glass Hatch 1 1 PA N I C 14 Using remote to open the glass hatch will suspend the arming mode. Once the hatch is closed, system will resume in arm mode. NOTE: Opening the glass hatch with a key will ACTIVATE the alarm. © 2004 American Honda Motor Co., Inc. - All Rights Reserved.
Panic • You can intentionally activate the horn and flash the head lights and parking lights by the remote control transmitter. • This is a convenient feature if you need to attract attention in case of an emergency. Activating the Panic Function 1 PA N I C Press and hold the “PANIC” button for more than 1 second. The following will occur. PA N I C • The horn sounds once per 1.5 seconds for one alarm duration. (Horn duration is 30 seconds.) The parking and head lights flash once per 1.
Tripped Sensor Warning and Indication Tripped Sensor Warning 1 16 • The system will warn you that the security system has been tripped in your absence. • If the system was tripped and auto rearmed you will observe the following: The status LED flashes twice per second. The parking lights flash 3 times when the system is disarmed. © 2004 American Honda Motor Co., Inc. - All Rights Reserved.
Tripped Sensor Warning and Indication Tripped Sensor Indication (using both the transmitter and iginition key) • After disarming the system, if the tripped sensor warning indicator appears, you can identify which sensor has been tripped by observing the number of flashes as shown below. • As a diagnostic tool, the tripped sensor can be recalled from memory regardless of whether the system had been armed. • There are two possible ways to indicate: • Method using both the transmitter and ignition key.
Tripped Sensor Warning and Indication Tripped Sensor Indication (using only the indication key) 1 2 Disarm the security system. Close the door. Insert the ignition key. 0 3 Within 1 second after step 2, open the door. 4 Within 1 second after step 3, remove the key from the ignition switch. The status LED will flash according to the sensors tripped.
Remote Control Code Programming (Only vehicles without Power Door Locks) How to Program Remote Control Transmitters • For steps 2 through 12, each step must be completed within 5 seconds. For step 13, within 10 seconds for each remote. • Up to four remotes can be stored in memory. • All remotes to be programmed must be on hand. • A non programmed remote will work for this procedure. • Turn the ignition key to the “OFF” position to complete the programming procedure. 1 2 Disarm the security system.
Remote Control Code Programming (Only vehicles without Power Door Locks) 6 7 Press the “LOCK” or “UNLOCK” button on the remote control transmitter. or Turn the ignition to the “OFF” position. ON 0 OFF 8 6 9 Turn the ignition to the “ON” position. ON 0 OFF 9 10 Press the “LOCK” or “UNLOCK” button on the remote control transmitter. or PA N I C Turn the ignition to the “OFF” position. ON 0 OFF 11 Turn the ignition to the “ON” position. ON 0 OFF 20 © 2004 American Honda Motor Co., Inc.
Remote Control Code Programming (Only vehicles without Power Door Locks) 12 or 13 12 13 Press the “LOCK” or “UNLOCK” button on the remote control transmitter. • The status LED illuminates simultaneously for 1 second to indicate programming mode. • To terminate the programming mode at this point, either turn the ignition key to the “OFF” position or leave the remote’s button untouched for over 10 seconds. To program the remote, perform steps 2 through 12.
Optional Items The Security System Accessories can be purchased at your Honda dealer. (Depending on the vehicle models, the installed accessories vary. For details, contact your Honda dealer.) To insure proper installation and operation, each accessory should be installed by your Honda dealer. Hood Switch For added protection of your Honda vehicle. *Only for the vehicles that have the installed accessory. The hood switch will trigger the alarm when the hood is opened.
Glossary Description ALARM DURATION The amount of time the horn sounds when the alarm is tripped or the panic feature is activated. The duration is 30 seconds for the horn respectively. ARM To turn the security system’s protection on. * AUTOMATIC The optional mode in which the security system is armed automatically (passively) after the trunk and all the doors (or hood)** are closed. The doors do not lock when the system is armed.
Glossary Description * EXTENDED EXIT ARMING If a door or the trunk is opened during the exit delay time, the timer will reset itself and will restart the count down procedure when that door or trunk is closed. PANIC A mode in which the horn or optional siren are intentionally activated. Useful for attracting attention in case of an emergency. SENSOR CANCELLATION A feature which cancels (ignores) a particular sensor which has caused the alarm to be tripped consecutively for 10 minutes.
Notes © 2004 American Honda Motor Co., Inc. - All Rights Reserved.
Notes 26 © 2004 American Honda Motor Co., Inc. - All Rights Reserved.
Notes © 2004 American Honda Motor Co., Inc. - All Rights Reserved.
Specifications Main Unit Design ......................................................................................... Microprocessor, all solid state Operating Voltage .................................................................... 13 V DC (9 V to 16 V allowable) Current Consumption (Arming) ......................................................................................... 2 mA Operating Temperature ......................................................................................