Full Product Manual

7
2. Adjust the length of the harness as shown in the figures below.
3. Roll the end of the harness toward your body and fasten it.
Check the Quick-Release Latch
1. Put on the carrying harness.
2. Check that the latch is released as soon as the quick-release
latch tab is pulled upwards while holding the hip pad with your
left hand.
For both shoulders
(UMC435)
For single shoulders
(UMC425)
CARRYING
HARNESS
CARRYING
HARNESS
HIP PAD
CARRYING
HARNESS
LATCH
HIP PAD
To make it shorter To make it longer
1
2
2
1
(UMC435) (UMC425)
Roll the end of the
harness and fasten it.
(There is one applicable
point on the back side of
your body)
Roll the end of the
harness and fasten it.
3. Insert the latch tongue in the slot of the quick-release latch to
reattach the powerhead to the carrying harness.
If the latch is not released, have your device inspected and repaired
by your servicing dealer.
Attachment Installation/Removal
Check the joint area:
1. Check to see if the set pin knob moves smoothly.
2. Check to see if the joint knob tightens and loosens smoothly,
and if there is any damage.
3. Make sure there is no debris in the groove and inside the joint
holder.
Installation:
1. Turn the set pin knob to the lock position and loosen the joint
knob.
2. Align the “ ” mark on the attachment with the joint projection
which also aligns the key of the attachment with the joint
groove.
Running this engine without an attachment in place
could cause an unsafe condition.
Moving parts could cause severe injury.
Do not run the engine without an attachment properly
secured.
QUICK-RELEASE
LATCH TAB
HOOK
QUICK-RELEASE
LATCH
HIP PAD
LATCH TONGUE
SLOT
JOINT HOLDER SET PIN KNOB (Back side of the portion where
the attachment is connected)
KEY
PROJECTION
JOINT KNOB
ATTACHMENT
JOINT HOLDER
GROOVE
LOOSEN
LOCK
1
2
3
31VP8600.fm Page 7 Friday, May 15, 2015 2:40 PM