Operation Manual

Engine Oil u Changing Engine Oil & Filter
78
Maintenance
7. Remove the oil filter with a filter wrench
from the right side and let the remaining
oil drain out.
u Discard the oil and oil filter at an
approved recycling centre.
8. Apply a thin coat of engine oil to the
rubber seal of a new oil filter.
9. Install the new oil filter and tighten.
10. Install a new sealing washer onto the
drain bolt. Tighten the drain bolt.
11. Fill the crankcase with the recommended
oil ( 2 P. 60) and install the oil fill cap.
12. Check the oil level. 2 P. 75
13. Check that there are no oil leaks.
14. Install the right under cover.
Rubber seal
Oil filter
Torque: 26 N·m (2.7 kgf·m, 19 lbf·ft).
Torque: 30 N·m (3.1 kgf·m, 22 lbf·ft).
Required oil
When changing oil & engine oil
filter:
3.1 litres (3.3 US qt, 2.7 Imp qt)
When changing oil only:
2.9 litres (3.1 US qt, 2.6 Imp qt)
15 VFR800X-32MJM8000.book 78 ページ ２０１４年１２月１９日 金曜日 午後１時４０分