User's Manual

3. PREPARATION
1. Connect the suction hose.
.Use commercially available hose, hose connector, and hose bands. The suc-
tion hose must be of reinforced, noncollapsible construction. Suction hose
length should not be longer than necessary, as pump performance is best
when the pump is not far above the water level. Self-priming time is also pro-
portional to hose length.
The strainer that is provided with the pump should be attached to the end of
the suction hose with a band, as shown.
CAUTION: Always install the strainer on the end of the suction hose before
pumping. The strainer will exclude debris that can cause clogging or impeller
damage.
NOTE: Tighten the hose connector and bands to prevent air leakage and loss
of suction. A loosely connected suction hose will reduce pump performance
and self-priming ability.
2. Connect the discharge hose.
Use a commercially available hose, hose connector, and hose band. A short,
large-diameter hose is most efficient. Long or small-diameter hose increases
fluid friction and reduces pump output.
NOTE: Tighten the hose band securely to prevent the hose NOTE: Tighten the hose band securely to prevent the hose
ing under high pressure. ing under high pressure.
D DISCHARGE
H H
from
disconnect-
5