Manualshelf

Owner's Manual

ManualsBrandsHonda ManualsWater PumpsHonda WDP20X WZBZ-6000351 through 9999999
51525354555657585960
SERVICING YOUR PUMP
50
5. Pull the recoil starter slowly until the diaphragm pulls up against
the upper case stops.
The crank arm should be approximately at the angle shown below.
6. Install the lower case, making sure the diaphragm is centered and
not pinched between the case stops. Tighten the hardware
following the torque procedure on page 48.
7. If removed, install the clappet valves. Refer to page 43.
8. Install the pump handle and springs.
9. Check the gear box oil level and fill if necessary. Refer to page 42.
10. Run and test the pump for correct operation.
DIAPHRAGM
UPPER
CASE
STOP (4)
UPPER
CASE
CRANK
ARM