User's Manual

OPERATION
SUCTION HOSE INSTALLATION
Use the commercially available hose and hose connector with the
hose clamp provided
with the pump. The suction -hose must be
reinforced
with a noncollapsible wall or braided wire construction.
The suction hose should be no longer than necessary. Pump
performance is best when the pump is near the water level, and the
hoses are short.
Use a hose clamp to securely fasten the hose connector to the suction
hose in order to prevent air leakage and
loss of suction. Verify that the
hose connector sealing washer is in good condition.
Install the strainer (provided
with the pump) on the other end of the
suction hose, and secure
it with a hose clamp. The strainer will help to
prevent the pump from becoming clogged
or damaged by debris.
Securely tighten the hose connector on the
pump suction port.
SUCTION PORT
HOSE CLAMP RING
SUCTION HOSE
HOSE CONNEC
18