Product Manual

49
STORAGE
Engine Oil
STORAGE PRECAUTIONS
Change the engine oil (see page ).
Loosen the 5 mm hex bolt with a hexagon wrench, then remove the
top cover (see page ).
Remove the spark plug (see page ).
Apply a couple of drops of clean engine oil into the cylinder.
Install the top cover temporarily.
Remove the top cover, then reinstall the spark plug.
Pull the starter grip several times to distribute the oil in the cylinder.
Move the choke lever to the CLOSED (upwards) position.
Pull the starter rope slowly until resistance is felt. This will close the
valves, so moisture cannot enter the engine cylinder. Return the
starter rope gently.
If your pump will be stored with gasoline in the fuel tank and
carburetor, it is important to reduce the hazard of gasoline vapor
ignition. Select a well-ventilated storage area away from any appliance
that operates with a flame, such as a furnace, water heater, or clothes
dryer. Also avoid any area with a spark-producing electric motor, or
where power tools are operated.
If possible, avoid storage areas with high humidity, because that
promotes rust and corrosion.
Place the pump on a level surface.
With the engine and exhaust system cool, cover the pump to keep out
dust. A hot engine and exhaust system can ignite or melt some
materials. Do not use sheet plastic as a dust cover. A nonporous cover
will trap moisture around the pump, promoting rust and corrosion.
Install the top cover, and tighten the 5 mm hex bolt securely with a
hexagon wrench (see page ).
1.
2.
3.
4.
5.
6.
7.
8.
37
38
9.
10.
37
32
09/03/16 19:02:38 31YE9603_050