Instructions / Assembly

©2008 honey-can-do international | all rights reserved
ASSEMBLY INSTRUCTIONS
INSTRUCTIONS
honey-can-do international 5750 McDermott Drive, Berkeley, IL 60163 USA tele 877.242.2636 fax [phone] www.honeycando.com
(QTY) DESCRIPTION ILLUSTRATIONPART
ITEM #
LIMITED LIFETIME WARRANTY
This product is warranted to be free of defects in material and workmanship for as long as the
consumer owns the product. At Honey-Can-Do’s option, defective product will be repaired,
replaced or substituted with a product of equal value. For warranty service, e-mail Honey-Can-Do
at [e-mail] or call at [phone]. You may also contact Honey-Can-Do
at 5750 McDermott Drive, Berkeley, IL 60163. Do not dispose of the defective item until or unless
you are specifically asked to do so by Honey-Can-Do as we may require return of the defective
item. Honey-Can-Do shall in no event be liable for any incidental or consequential damages.
Some states do not allow the exclusion or limitation of incidental or consequential damages, so
the above exclusion may not apply to you. This warranty gives you specific legal rights, and you
may also have other rights, which may vary from state to state.
IMPORTANT! Plead read prior to use. This Honey-Can-Do wood
knockdown Rack is designed for indoor use. Please do not over- load.
To prevent tipping, we recommend that you evenly distribute the
weight throughout the unit. Please keep drying bars horizontal when in
use. Please do not use rack for anything other than its intended use. Please
use caution when collapsing drying rack as fingers can be pinched by
collapsing side supports. Please keep away from heat sources such as
heaters, furnaces, and fireplaces.
A
B
1
Finish
2
(2) side supports
(10) dryer bars
Thank you for purchasing a Honey-Can-Do Drying Rack. Please follow
these step-by-step instructions. Please plan to spend about 10 minutes
assembling your new rack.
1. Expand one side support (A) and insert one drying bar (B) into hole
at position 1 (see step 1 drawing). Make sure that support bar (B) is
on the same side of (A) as the locking arm. Move the locking arm of
side support so that it locks in place around the drying bar (inset 1).
Open the second side support (A). With the locking arm facing the
first side support (A) insert the same drying bar (B) into hole at
position 1 (see step 1 drawing).
2. With both locking arms in locked position continue to insert remain-
ing drying bars starting at the top and working your way down to
the bottom.
3. When all bars are in place finish your installation by applying firm
even pressure by tapping both sides of drying rack together to
ensure all drying bars fit tightly.
For assistance, please contact us at [e-mail]
or 877.242.2636.
wood knockdown
drying rack
DRY-01174 | DRY-01168
locking arm
Place locking arm
in position around
drying bar before
continuing
assembly.
11 inch-279.4 mm
17 inch-431.8 mm