SHF-02217 SHF-02218 3-tier modular stacking urban shelf 14 in L x 15 in W x 30 in H (35.6 cm L x 38.1 cm W x 76.2 cm H) www.honeycando.com | sales@honeycando.com | 877.2.I.CAN.DO (877.242.
PARTS LIST PART/ILLUSTRATION (QTY) DESCRIPTION (3) shelf (4) top support poles section (small threaded opening is the top) (4) bottom support poles section (this section is missing rib on pole) D (4) E (24) F (4) pole connector shelf support clips (12 pairs) leveler feet (comes preassembled on some models) G H (4) post caps (4) stacking connector optional (used to stack multiple units) remove leveler feet and replace with (H) to stack second unit.
ASSEMBLY G B D C Note: Theend end with Note: The with thethe long long missinga ribthe spacespace missing a rib neat near is the bottom end isthe theend bottom support pole support section. pole section. } F 1. 2. 3. 4. Begin by identifying the top and bottom of pole support sections (B & C) see illustration above. Next insert support pole connector (D) between support pole sections and screw together. Repeat for all four support poles.
ASSEMBLY 2. Raised ridge on inside of clip 1. D D 1. 2. 3. The shelves (A) are held on with pairs of the shelf support clips (D). Align two halves of the shelf support clips (D) on the support pole at the desired height of the bottom shelf. ***When clips are together the form a slight cone shape. The top of the clips is the thin end.*** The shelf support clip (D) is in the proper place when the raised ridge on the inside of the clip locks into the ridge on the support pole.
ASSEMBLY 1. Slide all four poles through shelf. Once you have verified that all support clips are aligned push shelf firmly down until snug.
ASSEMBLY Raised ridge on inside of clip 1. 2. Repeat steps from page 4. Locate clips at desired height for middle shelf. Repeat steps from page 4. Locate clips at desired height for top shelf.
ASSEMBLY 1. Use leveler feet to adjust legs when shelf is on an uneven surface. **Warning: Steel shelving units should not be overloaded and heaviest items should be stored on the bottom shelf. DO NOT stand or climb on shelving units. If children are present shelving units should be secured to a wall to prevent tipping and injury.
**Warning: Steel shelving units should not be overloaded and heaviest items should be stored on the bottom shelf. DO NOT stand or climb on shelving units. If children are present and/or shelving units are stacked they should be secured to a wall to prevent tipping and injury. 1. 2. 3. 4. stacking additional unit 1. 2. 3. 4. 5. Remove the post cap(E) of lower unit. Remove lever foot(F) of upper unit. (Do not add shelves to upper unit until you have completed the following steps).