Instructions

Xenon XP User Guide 97
Streaming Presentation In-Stand
This option is available when using In-Stand Sensor Mode,page 94. You may
program a specific Streaming Presentation Mode for in-stand scanning, and a
Manual Trigger mode for out-of-stand scanning. To do this, you must first scan the
preferred Streaming Presentation mode (Normal or Enhanced), then scan the
Manual Trigger mode (Normal or Enhanced) you want to use.
Hands Free Time-Out
The Scan Stand and Presentation Modes are referred to as “hands free” modes. If
the scanner’s trigger is pulled when using a hands free mode, the scanner changes
to manual trigger mode. You can set the time the scanner should remain in manual
trigger mode by setting the Hands Free Time-Out. Once the time-out value is
reached, (if there have been no further trigger pulls) the scanner reverts to the
original hands free mode.
Scan the Hands Free Time-Out barcode, then scan the time-out duration (from 0-
300,000 milliseconds) from the Programming Chart, beginning on page 311, then
Save. Default = 5,000 ms.
Reread Delay
This sets the time period before the scanner can read the same barcode a second
time. Setting a reread delay protects against accidental rereads of the same
barcode. Longer delays are effective in minimizing accidental rereads. Use shorter
delays in applications where repetitive barcode scanning is required. Reread Delay
only works when in a Presentation Mode (see page 91). Default = Medium.
Hands Free Time-Out
Short (500 ms)
* Medium (750 ms)
Long (1000 ms)