Data Sheet

SAFETY SHOES
Page 2
TECHNICAL FORM
Réf. 62 006 15
CONFORT S3
I : Electrically insulation footwear
HI : Heat insulation of the sole complex
CI : Cold insulation of the sole complex
WR : Water resistance of the whole footwear
M : Metatarsal protection
AN : Ankle protection
CR : Cut resistance of the upper
HRO : resistance of the outsole to hot contact
In the event that there are none of these additional marks, the risks described above are not covered.
These guarantees are valid for footwear in good condition and the company cannot be held responsible for any usage not
provided for within the framework of this current information notice.
If the footwear is supplied with a removable insock, testing was carried out with the insock in place. Footwear should only
be used with the insock in place and the insock shall only be replaced by a comparable insock supplied by the original
footwear manufacturer.
If the footwear is supplied without an insock, testing was carried out with no insock present. Fitting an insock can affect the
protective properties of the footwear.
If the footwear is supplied with a part of, or the whole sole unit made of polyurethane:
We advise that the footwear should be used in the limit of 3 years following the manufacturing date, which figures on the
footwear. After this time limit, certain factors such as : exposure to sunlight, hydrometry, temperature changes, could
cause a modification in the structure of the material, which would no longer maintain the same performance levels with
regards to the requirements defined in the European Directive 89.686 CEE.
If the footwear is supplied with a sole unit made from a material other than polyurethane:
We advise that the footwear should be used in the limit of 5 years following the manufacturing date, which figures on the
footwear.
All of these time limits indicated, concern only new footwear in their original packaging, kept in a controlled stock area, not
subject to rapid changes in temperature or humidity levels.
This footwear has been designed and made taking your requirements into account and we hope that they will serve you
well.
Antistatic note for Safety Footwear,
in accordance with the EN ISO 20345:2004 & 20346:2004 Standard,
marked A, S1, S2, S3, P1, P2 or P3
Each pair of antistatic footwear shall be supplied with a leaflet containing the substance of the following wording.
Antistatic footwear should be used if it is necessary to minimize electrostatic build-up by dissipating electrostatic charges,
thus avoiding the risk of spark ignition of, for example flammable substances and vapours, and it the risk of electric shock
from any electrical apparatus or live parts has not been completely eliminated. It should be noted, however, that antistatic
footwear cannot guarantee an adequate protection against electric shock at it introduces only a resistance between foot
and floor. If the risk of electric shock has not been completely eliminated, additional measures to avoid this risk are
essential. Such measures, as well as the additional tests mentioned below, should be a routine part of the accident
prevention programme of the workplace.
BACOU-DALLOZ : ZI Paris Nord II - 33, rue des Vanesses - BP 50288 - 95958 Roissy CDG - France
Tél. : [phone] - Fax : [phone] - www.bacou-dalloz.com
www.bacou-dalloz.com