Installation Instructions

Product Description
Wireless Field Interface Part No.: 4417781
3 - 2 Installation Manual
3.2 SmartView
The SmartView is the basic tool in which the user can communicate with
the WFI modules. The SmartView can be delivered as a portable tool
and is optional. If you want to use SmartView then you can use a
SmartView board (FII-SMV) as an optional board. WFI has a provision
for an optional board.
FIGURE 3-2 Connecting WFI with Smartview
The SmartView is electrically connected to the Wireless Field Interface
through a cable. The connections to the Wireless Field Interface are
made inside the optional FlexConn module. The cable has four wires, a
shield and an optional a ground wire.
Mount an M20 cable gland to the Standalone SmartView, and connect
the other end to the external display connector located on the WFI
device.
WARNING! Intrinsically safe cabling may only be connected to
the outside 5 pin socket. Connection of non-intrin-
sically safe signals will invalidate the approval. The
electrical data of the intrinsically safe circuits is to be
taken from the ATEX/IECEx certificate (numbers see
below) which is shipped with the instrument. Any
deviation from the recommended FII-SMV cable
routing or Coax Cable routing invalidates the Ex
approvals.