User Manual

Commissioning
Part No.: 4417.762_Rev07 SmartRadar FlexLine
Service Manual 6 - 47
6.4.5.2.4.6 Other Tab (2)
The following example screen shows possible detail settings of the
Other tab.
Parameter Description
Alarm Test By selecting an alarm level to test - High high, High, Low, or Low low - and pressing
OK, the SmartRadar will perform an Alarm test command.
For detail settings, see 6.4.5.2.4.6.
Alarm Hysteresis This is the alarm hysteresis setting.
For detail settings, see 6.4.5.2.4.6.
Ullage Level Scale:
- EU at 100% Not used in the SmartRadar FlexLine
- EU at 0% Not used in the SmartRadar FlexLine
- Units Index In this field you can select the required engineering unit from the list of available units.
(level units for the level TB, and temperature units for the temperature TB).
Note: For supported units, see 6.4.5.2.8.