User Manual

Commissioning
Part No.: 4417.762_Rev07 SmartRadar FlexLine
Service Manual 6 - 51
The temperature details can be found on the Other tab that. This tab
has a different layout than it has in a standard transducer block. It is
described below.
Parameter Description
Alarm Test By selecting an alarm level to test - High high, High, Low, or Low low - and pressing
OK, the SmartRadar will perform an Alarm test command.
For detail settings, see 6.4.5.2.4.6.
Alarm Hysteresis This is the alarm hysteresis setting.
For detail settings, see 6.4.5.2.4.6.
Average Vapour temperature This is the average vapour temperature
EU at 100% (avg temp scale) Not used in the SmartRadar FlexLine
EU at 0% Not used in the SmartRadar FlexLine