User Manual

Safety
SmartRadar FlexLine Part No.: 4417.762_Rev07
2 - 2 Service Manual
2.3.2 EC Declaration of Conformity (for EU)
Refer to the EC declaration of conformity shipped with the device.
2.3.3 Control Drawings for FM & CSA
Refer to the control drawings shipped with the device.
2.3.4 Users
The mechanical and electrical installation must be carried out only by
trained personnel with knowledge of the requirements for installation of
explosion-proof equipment in hazardous areas.
The entire installation procedure must be carried out in accordance with
national, local, and company regulations.
The entire electrical installation shall be carried out in accordance with
the national requirements for electrical equipment to be installed in
hazardous areas.
NOTE: See EN IEC 60079-14 or NEC (NFPA70).
2.3.5 Additional Information
If you require additional information, contact Enraf or its representative.
2.3.6 Environmental Conditions
Observe the environmental conditions for the temperature and the
pressure.
2.4 Liability
The information in this installation guide is the copyright property of
Enraf B.V., Netherlands. Enraf B.V. disclaims any responsibility for
personal injury or damage to equipment caused by:
 Deviation from any of the prescribed procedures,
 Execution of activities that are not prescribed,
 Neglect of the safety regulations for handling tools and use of elec-
tricity.
The contents, descriptions and specifications in this Service Manual are
subject to change without notice. Enraf B.V. accepts no responsibility for
any errors that may appear in this Service Manual.
WARNING! Only certified technicians are authorized to make
changes on the SmartRadar configuration. All modifi-
cations must be in accordance to the guidelines as
set forth by Enraf. Modifications not authorized by
Enraf will invalidate the approval certificates.