User Manual

Commissioning
SmartRadar FlexLine Part No.: 4417.762_Rev07
6 - 124 Service Manual
All the HART universal commands and some common practice
commands are supported by HCI-HAO. These are listed in the below
tables.
HART Universal Ccommands
Command no. Description
0 Read Unique Identifier
1 Read Primary Variable
2 Read Loop Current and Percentage of Range
3 Read Dynamic variables and Loop Current
4Reserved
5Reserved
6 Write Polling Address
7 Read Loop Configuration
8 Read Dynamic Variable Classifications
9 Read Device Variable With Status
10 Reserved
11 Read Unique Identifier Associated with Tag
12 Read Message
13 Read Tag, Descriptor, Date
14 Read PV Sensor Information
15 Read Device Information
16 Read Final Assembly Number
17 Write Message
18 Write Tag, Descriptor, Date
19 Write Final Assembly Number
20 Read Long Tag
21 Read Unique Identifier Associated With Long Tag
22 Write Long Tag
HART Common Practice Commands
Command no. Description
34 Write Primary Variable Damping Value
35 Write Primary Variable Range Values
36 Set Primary Variable Upper Range Value
37 Set Primary Variable Lower Range Value
38 Reset Configuration Changed Flags
40 Enter / Exit Fixed Current Mode
41 Perform Self Test
42 Perform Device Reset
44 Write Primary Variable Units
48 Read Additional Device Status
50 Read Dynamic Variable Assignments
51 Write Dynamic Variable Assignments
53 Write Device Variable Units
54 Read Device Variable Information
55 Write Device Variable Damping Value
59 Write Number Of Response Preambles
72 Squawk
79 Write Device Variable
113 Catch Device Variable