User Manual

System Architecture
Part No.: 4417.762_Rev07 SmartRadar FlexLine
Service Manual 3 - 9
3.4 SmartView Display
3.4.1 General
By means of the SmartView most of the FlexConn module settings can
be controlled.
ESF07-0024
FIGURE 3-4 An impression of the SmartView
For each sensor and digital I/O function implemented on a FlexConn
module, a Primary Value screen becomes available on the SmartView
display.
In the left bottom quarter of the display, the Primary Value’s “Health”
status is shown:
Below the Status field, the Status category is displayed:
Status Display Text
Good
Uncertain uncertain
Bad bad
Status Category Display Text
actual
manual manual
last valid last valid
stored stored
instrument instrument
environment environment
general hardware fail hardware
general firmware fail software
general commissioning fail commission
general calibration fail calibration
general operational fail operational
><
<
<
MAIN