Use and Care Manual

Connect remaining wires from Step 8

Push down on the tabs to put the

wires into the inner holes of their

corresponding terminals on the wall plate

(one wire per terminal) until it is ﬁrmly in

place.

Gently tug on the wires to verify they are

secure.

Tip: If you need to release the wires again,

push down the terminal tabs on the sides

of the wall plate.

1. Ensure the

right R-switch

is in the up

position.

1. Set right

R-switch to the

down position.

Determine Correct RSwitch Position and Insert R-wire or wires

Set the R-switch up or down based on your wiring notes in Step 8. Insert wires

into the inner holes of the terminals on the wall plate. The tabs will stay down

once the wire is inserted.

If you have 1 RWire (R, RC, RH):

If you have 2 RWires (R, RC, RH):

2. Insert your

R-wire (R, Rh

or Rc) into

R-terminal.

2. Insert your Rc

wire into Rc-

terminal.

3. Insert your R

or Rh wire into

R-terminal.

This wiring is just an example,

actual wiring may vary.

33-00421ES_A.indd 11 11/7/2018 10:37:46 AM