User's Manual

DT7500SN V-Plex
TM
DUAL TEC



Motion Sensor - Installation Instructions
W
T
T
V-
V+
OPEN / OUVERTURE / APERTURA / APERTURA / OPEN
LOCATION / EMPLACEMENT / POSIZIONAMENTO / LOCALIZACIÓN / LOCATION
MOUNT / INSTALLATION / MONTAGGIO / MONTAJE / MOUNT
3
Range Adjustment Réglage de la portée hyper Regolazione della portata Ajuste del rango de detección Range Adjustment
5
2.1 - 2.4 m
(7 - 8 ft)
1
6
2
WIRE / CABLAGE / COLLEGAMENTO / CABLEADO / WIRE
IDENTIFY COMPONENTS AND SELECT APPROPRIATE SETTINGS / IDENTIFICATION DES COMPOSANTS ET SÉLECTION DES PARAMÈTRES APPROPRIÉS / IDENTIFICARE I COMPONENTI
E SELEZIONARE LE IMPOSTAZIONI APPROPRIATE / IDENTIFICAR LOS COMPONENTES Y SELECCIONAR LA CONFIGURACIÓN ADECUADA / IDENTIFY COMPONENTS AND SELECT
APPROPRIATE SETTINGS
1
Polling Loop 9 - 13VDC
SMB-10T
TAMPER
24 VDC,
10mA
0.3-1.3mm
2
(22-16 AWG)
Cover Tamper Switch Contact AP du capot Interruttore tamper sul coperchio Tamper de la cubierta Cover Tamper Switch
3
2
Rear Tamper Breakaway Tab Rear Tamper Breakaway Tab Rear Tamper Breakaway Tab Rear Tamper Breakaway Tab Rear Tamper Breakaway Tab
W
With SMB10T With SMB10T With SMB10T With SMB10T With SMB10T With SMB10T
ON
OFF
1
234
5
25%
50%
75%
100%
T
T
+
-
W
ON
OFF
1
234
5
Pulse Count 2
Low Sensitivity LED Disabled Microwave Walk Test OFF Anti-Mask OFF
Pulse Count 1
High Sensitivity
LED Enabled
Microwave Walk Test ON
Anti-Mask ON
LED
REPLACE CIRCUIT BOARD / REMISE EN PLACE DU PCB /
RIPOSIZIONARE IL CIRCUITO / VOLVER A COLOCAR LA
PLACA DE CIRCUITO IMPRESO / REPLACE CIRCUIT
BOARD
4
If installed with a Smart V-Plex
TM
Panel:
The sensor will not transmit or indicate intrusion alarms when the panel is disarmed; in the armed state, the sensor will respond to all communications to or with the host panel. If installed with a Standard V-Plex
TM
Panel:
The sensor will respond to all communications with the host panel armed or disarmed.
ON
OFF
1
234
5
Pulse Count 2
Low Sensitivity LED Disabled Microwave Walk Test OFF Anti-Mask OFF
Pulse Count 1
High Sensitivity
LED Enabled
Microwave Walk Test ON
Anti-Mask ON
<FR> If installed with a Smart V-Plex
TM
Panel: The sensor will not
transmit or indicate intrusion alarms when the panel is disarmed; in the armed state, the sensor will respond to all communications to or with the host panel. If installed with a Standard V-Plex
TM
Panel: The sensor will
respond to all communications with the host panel, armed or disarmed.
Use these holes when mounting to a standard U.S. electrical junction box
ON
OFF
1
2
Lowest Sensitivity: 3 - 5 Steps; Up to 45 kg (100 lb) Pet Immunity Lowest Sensitivity: 3 - 5 Steps; Up to 45 kg (100 lb) Pet Immunity Lowest Sensitivity: 3 - 5 Steps; Up to 45 kg (100 lb) Pet Immunity Lowest Sensitivity: 3 - 5 Steps; Up to 45 kg (100 lb) Pet Immunity Lowest Sensitivity: 3 - 5 Steps; Up to 45 kg (100 lb) Pet Immunity
ON
OFF
1
2
Low Sensitivity: 2 - 4 Steps; Up to 23 kg (50 lb) Pet Immunity Low Sensitivity: 2 - 4 Steps; Up to 23 kg (50 lb) Pet Immunity Low Sensitivity: 2 - 4 Steps; Up to 23 kg (50 lb) Pet Immunity Low Sensitivity: 2 - 4 Steps; Up to 23 kg (50 lb) Pet Immunity Low Sensitivity: 2 - 4 Steps; Up to 23 kg (50 lb) Pet Immunity
ON
OFF
1
2
Medium Sensitivity: 1 - 3 Steps; No Pet Immunity Medium Sensitivity: 1 - 3 Steps; No Pet Immunity Medium Sensitivity: 1 - 3 Steps; No Pet Immunity Medium Sensitivity: 1 - 3 Steps; No Pet Immunity Medium Sensitivity: 1 - 3 Steps; No Pet Immunity
ON
OFF
1
2
High Sensitivity: 1 - 2 Steps; No Pet Immunity High Sensitivity: 1 - 2 Steps; No Pet Immunity High Sensitivity: 1 - 2 Steps; No Pet Immunity High Sensitivity: 1 - 2 Steps; No Pet Immunity High Sensitivity: 1 - 2 Steps; No Pet Immunity
Look-Down Mask (install as shown when using Pet Immune Lens) Look-Down Mask (install as shown when using Pet Immune Lens) Look-Down Mask (install as shown when using Pet Immune Lens) Look-Down Mask (install as shown when using Pet Immune Lens) Look-Down Mask (install as shown when using Pet Immune Lens)
a
ON
OFF
1
234
5
Pulse Count 2
Low Sensitivity LED Disabled Microwave Walk Test OFF Anti-Mask OFF
Pulse Count 1
High Sensitivity
LED Enabled
Microwave Walk Test ON
Anti-Mask ON
<IT> If installed with a Smart V-Plex
TM
Panel: The sensor will not
transmit or indicate intrusion alarms when the panel is disarmed; in the armed state, the sensor will respond to all communications to or with the host panel. If installed with a Standard V-Plex
TM
Panel: The sensor will
respond to all communications with the host panel, armed or disarmed.
ON
OFF
1
234
5
Pulse Count 2
Low Sensitivity LED Disabled Microwave Walk Test OFF Anti-Mask OFF
Pulse Count 1
High Sensitivity
LED Enabled
Microwave Walk Test ON
Anti-Mask ON
<ES> If installed with a Smart V-Plex
TM
Panel: The sensor will not
transmit or indicate intrusion alarms when the panel is disarmed; in the armed state, the sensor will respond to all communications to or with the host panel. If installed with a Standard V-Plex
TM
Panel: The sensor will
respond to all communications with the host panel, armed or disarmed.
ON
OFF
1
234
5
Pulse Count 2
Low Sensitivity LED Disabled Microwave Walk Test OFF Anti-Mask OFF
Pulse Count 1
High Sensitivity
LED Enabled
Microwave Walk Test ON
Anti-Mask ON
<PT> If installed with a Smart V-Plex
TM
Panel: The sensor will not
transmit or indicate intrusion alarms when the panel is disarmed; in the armed state, the sensor will respond to all communications to or with the host panel. If installed with a Standard V-Plex
TM
Panel: The sensor will
respond to all communications with the host panel, armed or disarmed.
Wide Angle Lens (installed) Wide Angle Lens (installed) Wide Angle Lens (installed) Wide Angle Lens (installed) Wide Angle Lens (installed)
Pet Immune Lens (included) Pet Immune Lens (included) Pet Immune Lens (included) Pet Immune Lens (included) Pet Immune Lens (included)