Installation Instructions

e7w WIRELESS EMS THERMOSTAT - INSTALLATION INSTRUCTIONS
9 31-00308–01
STANDARDS AND APPROVALS
EN
• Product Standard − EN 60730-1:2011 and
EN 60730-2-9:2010 (covers EMC and LVD
Safety requirements).
• EMC Standard − ETSI 301489-1 V2.2.1, ETSI
301 489-17 V 3.2.0.
• EMC Standard EN 55032 − Radiated RF
Emissions.
UL (IEC)
• UL 60730-1, 5
th
edition and UL 60730-2-9,
4
th
edition.
• IEC and EN EMC standards:
o EU RoHs: EN 50581:2012 per EU RoHS
Directive 2011/65/EU,
o EN 50581:2012 per EU RoHS Directive
2011/65/EU.
o IEC60417, No.5957. For indoor use only.
o Class III equipment per IEC 61140.
• Radio – FCC Part 15 Subpart C (15.249), In-
dustry Canada RSS-210 Issue 9:2016 and
RSS-GEN Issue 4:2014.
• IPx1 protection.
• Pollution Degree 2.
• Type 1 action, operating control.
CSA
• CSA (IEC Based), Note 1 on standards,
Note 2 on aspects impacted by transition
• CAN/CSA E60730-1, 5
th
edition
• CAN/CSA E60730-2-9, 4
th
edition
Note 1
We have a choice of the IEC based path or
the updated version of Spec. 24. Considera-
tions:
• CSA C22.2 No. 24-93 has been in place
but will not be allowed from Jan. 1, 2017.
It is being replaced with CSA C22.2 No.
24-2015 as of that date (Environmental
Requirements).
• CSA C22.2 No. 24-2015 references CSA
C22.2 No. 0.8 for electronic controls with
safety functions, functional safety and
EMC instead of 60730-1 Annex H.
• According to CSA, the deviations for
Canada added to CAN/CSA 60730-1
and 60730-2-9 make this choice equiv-
alent to use of CSA C22.2 No. 24-2015.
Regulatory Compliance
UL Listing
This device meets UL 60730-2-9, CAN/CSA-
E60730-2-9 Standard for Automatic Electrical
Controls - Part 2-9: Requirements for Tempera-
ture Sensing Control
Federal Communications Commission
(FCC)
Changes or modifications not expressly ap-
proved by the party responsible for compliance
could void the user’s authority to operate the
equipment. This equipment has been tested and
found to comply with the limits for a Class B dig-
ital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a res-
idential installation. This equipment generates,
uses and can radiate radio frequency energy and,
if not installed and used in accordance with the
instructions, may cause harmful interference to
radio communications. However, there is no