User Manual
Table Of Contents
- ChapterTitleList - Technical Support
- ChapterTitleList - Regulatory Information
- ChapterTitleList - Information to the User
- ChapterTitleList - Table of Contents
- ChapterTitle - About WaveLAN/IEEE
- ChapterTitle - Hardware Installation
- ChapterTitle - Installation for Windows
- ChapterTitle - Advanced WaveLAN Parameters
- ChapterTitle - Monitoring WaveLAN Performance
- ChapterTitle - WaveLAN Security Options
- ChapterTitle - Card Specifications
- ChapterTitle - Troubleshooting
- ChapterTitle - Installing in Windows CE
- ChapterTitle - Installation for MS-DOS
- ChapterTitle - Installing in Apple Macintosh
- ChapterTitle - Warranty Repair Card
- ChapterTitleList - List of Figures
- ChapterTitleList - List of Tables
- ChapterTitleList - Index
Installation for MS-DOS
Setup the WaveLAN Parameters
WaveLAN IEEE 802.11 PC Card User’s Guide D-19
NOTE:
When modifying the “
NET.CFG” file ensure that all
WaveLAN parameter lines will be indented. Use the
key of your keyboard to create an indent at the beginning
of each line that will contain a WaveLAN parameter.
3. When finished, save the “
NET.CFG” file and restart your
computer.
4. Proceed with “Finishing Installation” on page D-25.
Packet Driver Configuration D
The installation of the WaveLAN Packet Driver is a procedure that
requires you to edit a number of system files manually.
To ensure that the WaveLAN Packet Driver is loaded at start-up,
you will need to add a few command line statements to the
“AUTOEXEC.BAT” file.
These statements should include:
■ A path to the directory that contains the Packet Driver.
■ A “load driver” statement.
The WaveLAN parameters will be identified in a network
configuration file called “
PACKET.INI”.
The WaveLAN Packet Driver and the “
PACKET.INI” file must reside
in the same directory on the hard disk of your computer. When you
used the commands as identified “Copy the WaveLAN Software”
on page D-3, this directory is typically
c:\wavelan\drivers\packet.
Setup the WaveLAN Packet Driver D
1. Edit the “AUTOEXEC.BAT” file of your computer to add the path
and file name of the WaveLAN Packet Driver, and the “load
driver” statement:
TAB