Installation Guide

OneWireless Adapter Honeywell Documentation Rev A2 2 November 2010
Professional Installation Guide XXXXXXXXX Page 17 of 20
15 Agency Compliance
15.1 Radio and EMC Certifications
15.1.1 Federal Communication Commission (FCC)
¾ Specification: FCC Part 15.247 Subpart B for unintentional radiators
¾ Specification: FCC Part 15.247 Subpart C for intentional radiators
15.1.2 Industry Canada (IC)
¾ Method: RSS-210, Issue 7
¾ RSS-Gen, Issue 2
¾ ICES-003, Issue 4
15.1.3 European Telecommunications Standards Institute (ETSI)
¾ Emissions Specification and Method: EN 300 328 V1.7.1
¾ Emissions Spec and Method: EN 301 893 V1.3.1
¾ Immunity Specification: EN 301 489-17 V1.2.1
¾ Immunity Method: EN 301 489-1 V1.6.1
¾ Product Standard: IEC61326-1 (1
st
Edition, 2002-02, Industrial Locations)
15.2 Product Safety Agency Certifications
15.2.1 Canadian Standards Association (CSA)
¾ ANSI/ISA S82.02.01 (61010-1) CSA C22.2 No. 1010-1, ANSI/UL 61010-1, Safety Standard for Electrical
Equipment for Measurement, Control and Laboratory Use – Part 1: General Requirements
¾ C22.2 No. 0, General Requirements - Canadian Electrical Code, Part II
¾ C22.2 No. 94, Special Purpose Enclosures, Industrial Products
¾ C22.2 No. 142, Industrial Control Equipment, Industrial Products
¾ C22.2 No. 157, Intrinsically Safe and Non-Incendive Equipment for Use in Hazardous Locations
¾ C22.2 No. 213, Non-Incendive Electrical Equipment for Use in Class I, Division 2 Hazardous Locations
¾ E60079-0, Electrical Apparatus for Explosive Gas Atmospheres, Part 0: General Requirements
¾ E60079-15, Electrical Apparatus for Explosive Gas Atmospheres, Part 15: Electrical Apparatus With Type of
Protection "n"
¾ CSA C22.2 No. 60529, Degrees of Protection Provided by Enclosures (IP Code)
¾ CSA E61241-1-1, Electrical Apparatus for Use in the Presence of Combustible DustTemperature code: T4 (135°C)
based on the maximum specified ambient of 85°C.
15.2.2 Factory Mutual (FM)
¾ ANSI/ISA S82.02.01 (61010-1) CSA C22.2 No. 1010-1, ANSI/UL 61010-1, Safety Standard for Electrical
Equipment for Measurement, Control and Laboratory Use – Part 1: General Requirements
¾ Factory Mutual Approval Standard Class No. 3600, “Electrical Equipment for Use in Hazardous (Classified)
Locations – General Requirements